Fibreglass, rubber and torch-on felt

Flat Roofing & Flat Roof Repairs Leeds, Otley & Ilkley

Flat roofs fail when somebody lays them genuinely flat. We build the falls in first, match the membrane to the shape of the roof, and detail the upstands and edges so water leaves instead of sitting there.

Flat Roofing in Otley, Wharfedale and Leeds

The deck is where our survey starts. If the boards have gone soft, or the water has nowhere to run, a new skin laid over the top inherits both faults, and we will tell you that rather than take the job on. Once the deck is right the system follows the roof: GRP for smaller, busier shapes with upstands and rooflights, EPDM for a clean span such as a garage, three-layer torch-on felt where the build-up or the budget points that way.

Extensions, dormers, garages, porches and the bay tops on the Victorian and Edwardian housing through Otley and Ilkley. Nearly every property we visit has a flat roof somewhere, and most have had a tin of bitumen paint over them at least once. Laid properly, a flat roof is not second best. Fibreglass and rubber will both run for decades on a sound deck with falls that work.

Signs the flat roof is done

  • Water still standing two days after the rain stopped
  • Blisters, bubbles, or a patchwork of black paint from earlier attempts
  • Splits along the edge trim or where the roof meets the house wall
  • A soft, spongy give underfoot when you step onto the deck
  • Damp appearing on the ceiling below, usually closest to the wall
  • Silt and moss gathering in the low corners and around the outlet

If you recognise any of that, ring 0113 460 1042 or book the free survey. Somebody comes out, looks at it properly and puts the price on paper.

What the job covers

GRP fibreglass

Laid wet onto new OSB3 decking as one seamless skin, with moulded trims and your choice of topcoat colour.

EPDM rubber

A single bonded sheet with no seams to open up. Usually the answer on garages and larger extension roofs.

Torch-on felt

Three-layer high-performance systems, lapped and detailed properly, where felt is the sensible choice.

Firrings and falls

Tapered timbers set so the water runs to the outlet instead of gathering in the middle of the roof.

Upstands and abutments

Membrane carried up the wall and taken under lead, so the junction is sealed rather than painted.

Warm roofs and rooflights

Insulation above the deck to stop condensation, with kerbs built and flashed for lanterns.

Step by step on site

1. Check the structure, not the surface

Deck, falls and outlets inspected and photographed, with a written note of what is underneath.

2. Recommend one system

GRP, EPDM or felt, with the reason it suits your roof rather than the other two.

3. Price it in writing

Deck, insulation, membrane, trims, outlets and disposal each on their own line.

4. Lay it, flood it, guarantee it

Most domestic flat roofs are one to three days. Water tested in front of you and guaranteed in writing for ten years.

Why use Otley Roofing for flat roofing

  • We correct the falls instead of resurfacing a roof that cannot drain
  • GRP goes onto new decking as standard, never rolled over tired felt
  • EPDM in a single sheet, so there are no joints waiting to open
  • Warm-roof insulation priced alongside the cold option on any room you live in
  • Upstands taken under new or existing lead, not sealed with a tube of mastic

The patch we cover

We work out of Otley (LS21), up and down Wharfedale and the Washburn, and across every Leeds postcode. Flat roofing in Otley · Flat roofing in Ilkley · Flat roofing in Burley-in-Wharfedale · Flat roofing in Menston · Flat roofing in Guiseley · Flat roofing in Yeadon · Flat roofing in Horsforth · Flat roofing in Pool-in-Wharfedale · Flat roofing in Bramhope · Flat roofing in Headingley · Flat roofing in Leeds Centre · Flat roofing in Wetherby — or see every area we cover.

Flat Roofing: questions we get asked

  • GRP or EPDM on a sound deck with real falls should give twenty-five years or more. Felt depends on grade; a proper three-layer system is fifteen to twenty.
  • We would rather not. Old felt hides wet decking and bad falls, and anything laid over it takes those faults on. We open it up, look, and tell you what is there.
  • GRP copes with awkward shapes, dormers and upstands. EPDM suits large simple spans. Both are excellent laid correctly, so the recommendation follows the roof.
  • Little. The work is outside and usually one to three days, though a fibreglass roof wants a dry spell to cure properly.
  • On a room you actually use, yes. Insulation over the deck with the vapour control layer beneath is the correct build-up, and we quote it next to the cold option so you can compare.
  • Yes, when the failure is local and the deck under it is dry. GRP and EPDM patches are quick. Blistering across the whole roof usually means replacement.
Related jobs

Every roofing service we offer.

Extension or garage roof letting water in?

Free survey of the deck and the falls, a straight recommendation and an itemised written quote.

OpenUntil 5pm
Call
0113 460 1042
Free
Quote